A little advice would be nice!!

Renault & Alpine General Discussion
no avatar
User

jaimiew

Rank

Non Member

Posts

10

Joined

Wed Apr 20, 2005 9:21 pm


Has thanked: 0 time
Been thanked: 0 time

A little advice would be nice!!

Postby jaimiew » Tue Jun 21, 2005 10:38 am

I have been a regular visitor to the site, but this is my first posting, so I apologise in advance if I bore any of you.

I am the proud (but eternally frustrated) owner of a Black 87 GTA Turbo which I use as my everyday transport. I must also add that I am a complete pelican where cars are concerned, where to put the petrol, oil and water is about the limit of my mechanical knowledge. My GTA seems to suffer from just about every problem covered by the other threads on this site, dodgy electrics, leaking fuel hoses and cooling problems. It is the cooling problems which are causing greatest concern at this time and was wondering if anyone could give a bit of diagnostic advice.

From cold the engine starts no problem, but for the first couple of miles the engine is not very responsive and runs lumpy with some black smoke from the exhaust, once the temp is up everything settles down and it goes like the train that I love, whilst moving the temp never rises above 90 but as soon as I hit traffic the guage heads skywards and billows of white smoke belch from the exhaust. If I have an unimpeded journey, coolant levels remain pretty constant but otherwise I need to add about 2 liters of fluid, I cannot see any obvious leaks in hoses so where is all this fluid going??? If anyone can point me in the right direction it would be much appreciated.

On an unrelated issue, going back about 12 years, I used to own a Silver GTA Turbo D66 NGH. Has anyone seen it, or does anyone own it, it would be nice to know if it was still out there doing it's stuff.
User avatar
User

peterg

Rank

Non Member

Posts

2501

Joined

Wed Apr 14, 2004 10:26 pm

Location

Cumbria


Has thanked: 0 time
Been thanked: 0 time

Postby peterg » Tue Jun 21, 2005 10:50 am

White smoke from the exhaust is usually steam and the loss of fluid means its probably starting to blow a head gasket. Does your radiator fan cut in? When you get to 90 or thereabouts it should come in and its quite noisy...you'd know if it was. The fact that the car stays cool on the move means that your radiator is ok.
To me it sounds like the beginnings of head gasket failure.
no avatar
User

Alan Moore

Rank

Non Member

Posts

251

Joined

Thu Jul 01, 2004 1:04 pm

Location

Brisbane Australia


Has thanked: 0 time
Been thanked: 4 times

Postby Alan Moore » Tue Jun 21, 2005 11:32 am

Burnt glycol type coolant makes a white steamy smoke that disappears quickly, and has a sweet type of smell. Yes, it does sound like a blown head gasket or possibly head corrosion. It really needs to be sorted now, but will be reasonably costly if you can't do it yourself.
GTA V6 Turbo
Renault 4CV 16TS Power
BMW 2002 Tii M3 Power
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Postby clee » Tue Jun 21, 2005 11:32 am

Does sound like head gasket,unscrew the expansion tank cap when its running ( not to hot tho :!: ) If the gaskets failing you will smell exhaust gases in the water system :(
User avatar
User

simontaylor

Rank

Non Member

Posts

5602

Joined

Thu Apr 15, 2004 12:33 pm

Location

Fleet, Hampshire


Has thanked: 44 times
Been thanked: 56 times

Postby simontaylor » Tue Jun 21, 2005 11:49 am

Is it not possible to pressure test the cooling system, then you'll know if it is a head gasket problem or not?
Where are you based Jamie?
1986 : '86 GTA v6 BW-EFR turbo, with Adaptronic ECU
Firsts at
2007 : Gurston Down & RAOC Champion
2008 : Rushmoor & Eelmoor & ACSMC Hillclimb class Champion
2009 : Longcross & Eelmoor
2010 : Crystal Palace & Eelmoor
2016 : Rushmoor & 5th O/A
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Postby clee » Tue Jun 21, 2005 12:15 pm

The best pressure test you can do is to run the thing up to temp and look,the waters going somewhere ,so if it ain't on the floor .............
no avatar
User

jaimiew

Rank

Non Member

Posts

10

Joined

Wed Apr 20, 2005 9:21 pm


Has thanked: 0 time
Been thanked: 0 time

Postby jaimiew » Tue Jun 21, 2005 12:55 pm

Thanks for all the replies, I seem to get the impression that the general consensus is that it is head gasket failure, so I will certainly get it looked at. I can't say that I have noticed the fan cutting in either so I suppose I better look into that aswell. (Payday soon).

I am based down on the South Coast, 10 miles outside Worthing. Anyone know any decent mechanic down this area. Spoke to my local Renault dealer and can you beleive it, they didn't even know what a GTA was???
no avatar
User

TONY LAW

Postby TONY LAW » Tue Jun 21, 2005 2:48 pm

Hi Jamie

If this is your car: http://www.renaultalpine.co.uk/PHPBB/ph ... highlight=

Then, yes you need the headgasket(s) replacing

Welcome to the joys of GTA ownership!!

Regards
Stephen (using Tony Law's ID!!)
User avatar
User

Juzzblack

Rank

Non Member

Posts

982

Joined

Sun May 16, 2004 10:49 pm

Location

Charlotte, USA


Has thanked: 0 time
Been thanked: 0 time

Postby Juzzblack » Tue Jun 21, 2005 3:17 pm

Sounds like similar symtoms to what my GTA was suffering before I had my head gaskets done a few months ago. It was billowing white 'smoke'I so I had several compression tests and tests for exhaust gases in the coolant done, non of which were conclusive. What finally convinced me was, if I put my hand over the exhaust while it was billowing the white smoke my hand had a slight sticky residue and it smelt sweet. The white 'smoke' was actually steam and the smell was antifreeze! Worth doing this check on yours to see if it helps to clarify if it is your head gaskets leaking.

My geography's terrible but the only Alpine specialists I know down south are Alpine Renault Racing in London and Roadspeed in Stroud, Gloucestershire.

I had a local garage do mine, but a specailist would have been better!
GTA V6 Turbo - BTW check your earths!

Image

http://www.youtube.com/user/AlpineGTA
no avatar
User

jaimiew

Rank

Non Member

Posts

10

Joined

Wed Apr 20, 2005 9:21 pm


Has thanked: 0 time
Been thanked: 0 time

Postby jaimiew » Tue Jun 21, 2005 3:59 pm

Tony,

Yes that is the one, I was the self same bidder on e-bay who was the lucky (or unlucky) highest bidder. I didn't pay as much as shown as when I went to view the car there was quite a bit not working which the dealer had failed to note. I did notice the discoloration around the header tank but when removed the cap the seal was totally shot. One new cap later, problem solved and no trouble, UNTIL NOW :cry:
User avatar
User

peterg

Rank

Non Member

Posts

2501

Joined

Wed Apr 14, 2004 10:26 pm

Location

Cumbria


Has thanked: 0 time
Been thanked: 0 time

Postby peterg » Tue Jun 21, 2005 4:11 pm

I bet you wish you'd read that thread! Still it was cheap for a turbo...I just hope my prediction at the end of the thread isnt right.
If its just head gaskets any competent garage will beable to do them.....at the end of the day its a fairly common engine and you shouldnt need any specialist tools or parts. Theres an old thread when Juzz had his done that should be of assistance.
User avatar
User

Juzzblack

Rank

Non Member

Posts

982

Joined

Sun May 16, 2004 10:49 pm

Location

Charlotte, USA


Has thanked: 0 time
Been thanked: 0 time

Postby Juzzblack » Tue Jun 21, 2005 5:10 pm

GTA V6 Turbo - BTW check your earths!

Image

http://www.youtube.com/user/AlpineGTA
User avatar
User

peterg

Rank

Non Member

Posts

2501

Joined

Wed Apr 14, 2004 10:26 pm

Location

Cumbria


Has thanked: 0 time
Been thanked: 0 time

Postby peterg » Tue Jun 21, 2005 5:40 pm

What I couldnt remember was wether it was an engine out job for the head gaskets? If it is then you will need to check out how to jack the car up to remove the engine and sub frame (only 2 normal jacking points make it less simple than a normal car).......if not then any competent garage will be able to do the job.
User avatar
User

LiamMcShane

Rank

Non Member

Posts

512

Joined

Fri Oct 01, 2004 12:39 pm

Location

Shenzhen, China


Has thanked: 1 time
Been thanked: 0 time

Postby LiamMcShane » Tue Jun 21, 2005 6:48 pm

From what I can remember from previous threads (I'm good at the theory, but shit at the practical :lol: ), the head gaskets can be replaced with the engine in situ, but timing the engine back up is apparently not very easy! Better to take it out and be done with it! Having said that, I also remember being told that the engine can come up and out, without having to be dropped out with the subframe etc.
'88 GTA V6 Turbo

http://www.perfect-display.com.cn
Perfect Display Technology Company Ltd, Shenzhen
User avatar
User

David Gentleman

Rank

Non Member

Posts

3474

Joined

Thu Apr 15, 2004 8:10 am

Location

Colchester, Essex


Has thanked: 0 time
Been thanked: 0 time

Postby David Gentleman » Tue Jun 21, 2005 7:47 pm

Can be done in situ if you enjoy hours of backache from leaning over an engine bay, though as Liam says, timing it up is difficult and frustrating.. :shock: :? :? :cry:
Image
Next


  • Advertisement

Who is online

Users browsing this forum: Google [Bot], Majestic-12 [Bot] and 203 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France