Moderators: eastlmark, Test Moderator
Club Member
5097
Wed Jun 30, 2004 9:12 am
Sandbach
Non Member
10431
Fri May 28, 2004 11:58 am
Derbyshire
Club Member
5097
Wed Jun 30, 2004 9:12 am
Sandbach
clee wrote:The rear casing is different on the 25 in that it has an additional small outlet as well as the big one to the Y pipe.Usually you only get the main body as a new unit and bolt the old thermo housing and rear casing on .It's probably just a leaking gasket on one or the other .
I have one from a 25 in the garage ,it looks OK .You can swap the casings or plug the smaller bore .
Have a look if you're passing .
It looks far better than this anyway and probably cheaper
http://cgi.ebay.co.uk/renault-25-water- ... dZViewItem
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Club Member
5097
Wed Jun 30, 2004 9:12 am
Sandbach
Stunned Monkey wrote:If it's leaking from behind, then it's likely to be the back plate, as Lee says. When the actual pump shaft seal fails, they leak from a small hole behind the pulley.
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Users browsing this forum: No registered users and 38 guests