Wanted - 24V PRV n/a pistons

.
Hi folks,

Any 24v n/a pistons knocking about on peoples shelves or under benches not needed? I don't need a complete set, couple will do, but will take a full set if needed

Thanks,
Martin

Martin,
Do you have a set off 24vl. cam covers...they only want to sell me engines over here...not 24vl...I am changing my ignition from Ford coil pack to VW. coil on plug.
Cheers Eddie.

.
Hi Eddie,

Yes I should have rocker covers, I will have a look. Do you have any spare 24v pistons, 1 or 2 would be great? I have a set of real tatty seconds, and destined for Tatmo. If I have no choice I will dress them up, as this is a real project dole racer, but prefer to swap out a couple of the ones that have been knocked out of the liner with a hammer in a previous life (judging by the rings, were rusted in, and crown with a headache..)..

Did you mean complete 12V or completed 24V engines you are being offered? Buy one between us? I'm sure you will use the inlet manifold etc, I need pistons..

Cheers,
Martin

No sorry Martin only 12vl....I had 4 x 24vl at one point...1 in my car...1 in a German 310 with the same tb,s...1 to a guy with a GTA who was fitting a Merc v6 compresser...& the last 1 to a guy here in the islands who was building a mid-engine...since Jan retired & I got my place in Leiden I,ve lost touch with everyone...so sorry no pistons...were you & Guy at 1 point not going to have high compression one made...need the other cam covers to fabricate mounting points for the plate to take the coils.
Cheers Eddie.

[BIG_MVS]

Yo Faulksie might have something for you. Check your PM's!