Moderators: eastlmark, BIG_MVS, Test Moderator
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Club Member
2027
Sat Nov 13, 2004 12:46 pm
Saffron Walden- North Essex
Club Member
206
Wed Sep 27, 2006 9:41 am
London
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
mettersl wrote:My 610 had a gearbox leak until the roll pins were resealed. Dry after that (although the crank pulley seal was a little damp especially with thin oils).
Where is yours leaking from? The main spilt joint or somewhere else?
There are some good wick In Oil sealing compounds out ther,e I am told...
Cheers
Lee
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Club Member
206
Wed Sep 27, 2006 9:41 am
London
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
725
Thu Apr 14, 2005 9:06 am
Hampshire
Non Member
10431
Fri May 28, 2004 11:58 am
Derbyshire
Non Member
3709
Mon Apr 18, 2005 7:11 am
Alpine France
Miles wrote:My plan here would be to have a rad fan temp switch refitted to radiator.
Has anyone retrofitted the original or know of one that I can easily fit?
Secondly and more of an interim would be to connect the original fan stat wiring (which is currently doing nothing) and route it to a cabin switch, so I can switch on when I feel it would be beneficial.
Thirdly, I feel I should change map to default to above fan cut in threshold, if readings spurious.
Any advice, thoughts would be appreciated.
Users browsing this forum: No registered users and 33 guests